Publisher Description
This app will tell you how to Dismantle your AR15 and put it back together.Includes- Turn the selector to 'SAFE'. If the weapon is not cocked, the lever cannot be turned to safe. If there is a magazine in the rifle, remove it. Lock the bolt open by pulling the charging handle rearward, pressing on the bottom of the bolt catch, and allowing the bolt to move forward until it engages the bolt catch. Return your charging handle to the forward position.Look in the receiver and chamber to ensure these areas contain no ammunition. With the selector on safe, allow the bolt to go forward by pressing the upper portion of the bolt catch.DISASSEMBLE YOUR RIFLERemove the sling.Remove the handguards. Push the takedown pin as far as it will go.Push the receiver pivot pin. Separate the upper and lower receivers.Pull back the charging handle and remove the bolt carrier and bolt. Remove the charging handle.Remove the firing pin retaining pin. Do not open or bend the split end of retaining pin. Put the bolt assembly in the locked position by pushing in the bolt assembly.Remove the firing pin by letting it drop out of the rear of the bolt carrier into your hand. Remove the bolt cam pin by turning it one-quarter turn and lifting it out,Pull the bolt assembly from the bolt carrier. Remove the extractor pin by using the firing pin to push it out. Do not damage the tip of the firing pin.Lift out the extractor and spring. Do not separate the spring from the extractor. Press in the buffer, depress the retainer, and release the buffer.Remove the buffer and action spring. Separate the buffer from the spring. CLEAN, AND LUBRICATE YOUR RIFLEClean the barrel from the receiver end, going through the flash suppressor, and do not reverse direction while in the bore.Clean the barrel locking lugs and the gas tube in the upper receiver. Use a worn bore brush clean outside surface of protruding gas tube. Clean the buffer and inside lower receiver extension, making sure to clean the drain hole with a pipe cleaner.Brush dirt and powder from the trigger mechanism and lower receiver. Clean the bolt carrier group.Clean the outer and inner surfaces of the bolt carrier. Clean the carrier key. Clean the firing pin recess and firing pin. Clean the firing pin hole with a pipe cleaner. Clean the carbon deposits and dirt from the locking lugs. Clean the areas behind the bolt ring and under the lip of the extractor.INSPECT YOUR RIFLE BEFORE ASSEMBLY.BOLT - Check for cracks or fractures especially in the cam pin hole area; bolts that contain pits extending into the firing pin hole need replacing.FIRING PIN - Bent, cracked or blunted end.